Packages

nerves_system_rpi3a

1.9.2
2.1.0 2.0.4 2.0.3 2.0.2 2.0.1 2.0.0 2.0.0-rc.3 2.0.0-rc.2 2.0.0-rc.1 retired 2.0.0-rc.0 retired 1.33.1 1.33.0 1.32.0 1.31.4 1.31.3 1.31.2 1.31.1 1.31.0 1.30.1 1.30.0 1.29.1 1.29.0 1.28.1 1.28.0 1.27.1 1.27.0 1.26.0 1.25.1 1.25.0 1.24.1 1.24.0 1.23.2 1.23.1 1.23.0 1.22.2 1.22.1 1.22.0 1.21.2 1.21.1 1.21.0 1.20.2 1.20.1 1.20.0 1.19.0 1.18.4 1.18.3 1.18.2 1.18.1 1.18.0 1.17.3 1.17.2 1.17.1 1.17.0 1.16.2 1.16.1 1.16.0 1.15.1 1.15.0 1.14.0 1.13.3 1.13.2 1.13.1 1.13.0 1.12.2 1.12.1 1.12.0 1.11.2 1.11.1 1.11.0 1.10.2 1.10.1 1.10.0 1.9.2 1.9.1 1.9.0 1.8.2 1.8.1 1.8.0 1.7.2 1.7.1 1.7.0 1.6.3 1.6.2 1.6.1

Nerves System - Raspberry Pi 3 A+ and Zero 2 W

HexDocs

Current section

Files

Jump to
Readme
84 Versions
4 Dependencies
Dependants
Files
Activity
nerves_system_rpi3a cmdline.txt
Raw

cmdline.txt 

# NOTES:

# 1. A console is available via the gadget USB port. If you have a USB A ->

#    USB A cable, you can power and view console messages with one cable

# 2. To output kernel messages via the UART pines, add "console=serial0,115200".

#    serial0 is magically replaced with ttyAMA0 or ttyS0 depending on the

#    serial port configuration in config.txt.

# 3. To output kernel messages over HDMI, add

#    "console=tty1 fbcon=scrollback:1024k consoleblank=0"

# 4. "dwc_otg.lpm_enable=0" is a default copied over from Raspbian

# 5. If you're experimenting with kernel commandline parameters, it's easist

#    to modify this file on the MicroSD card via your development computer. To

#    make changes permanent, you'll need to override the fwup.conf.

dwc_otg.lpm_enable=0 root=/dev/mmcblk0p2 rootwait