Packages

nerves_system_rpi0

1.13.3
2.1.0 2.0.4 2.0.3 2.0.2 2.0.1 2.0.0 2.0.0-rc.3 2.0.0-rc.2 2.0.0-rc.1 retired 2.0.0-rc.0 retired 1.33.1 1.33.0 1.32.0 1.31.4 1.31.3 1.31.2 1.31.1 1.31.0 1.30.1 1.30.0 1.29.1 1.29.0 1.28.1 1.28.0 1.27.1 1.27.0 1.26.0 1.25.1 1.25.0 1.24.1 1.24.0 1.23.2 1.23.1 1.23.0 1.22.2 1.22.1 1.22.0 1.21.2 1.21.1 1.21.0 1.20.2 1.20.1 1.20.0 1.19.0 1.18.4 1.18.3 1.18.2 1.18.1 1.18.0 1.17.3 1.17.2 1.17.1 1.17.0 1.16.2 1.16.1 1.16.0 1.15.1 1.15.0 1.14.1 1.14.0 1.13.3 1.13.2 1.13.1 retired 1.13.0 1.12.2 1.12.1 1.12.0 1.11.2 1.11.1 1.11.0 1.10.2 1.10.1 1.10.0 1.9.2 1.9.1 1.9.0 1.8.2 1.8.1 1.8.0 1.7.2 1.7.1 1.7.0 1.6.3 1.6.2 1.6.1 1.6.0 1.5.1 1.5.0 1.4.0 1.3.0 1.2.1 1.2.0 1.1.1 1.1.0 1.0.0 1.0.0-rc.1 1.0.0-rc.0 0.21.0 0.19.2 0.19.1 0.19.0 retired 0.18.2 0.18.1 0.18.0 0.17.1 0.17.0 0.16.0 0.15.0 0.14.0 0.13.0 0.12.0

Nerves System - Raspberry Pi Zero and Zero W

HexDocs

Current section

Files

Jump to
Readme
111 Versions
3 Dependencies
Dependants
Files
Activity
nerves_system_rpi0 cmdline.txt
Raw

cmdline.txt 

# NOTES:

# 1. Kernel messages are output via the UART pins.

# 2. serial0 is magically replaced with ttyAMA0 or ttyS0 depending on the

#    serial port configuration in config.txt.

# 3. To output kernel messages over HDMI, add

#    "console=tty1 fbcon=scrollback:1024k consoleblank=0"

# 4. If you're experimenting with kernel commandline parameters, it's easist

#    to modify this file on the MicroSD card via your development computer. To

#    make changes permanent, you'll need to override the fwup.conf.

# 5. See https://www.raspberrypi.org/documentation/configuration/cmdline-txt.md

root=/dev/mmcblk0p2 rootwait console=serial0,115200 quiet